How To Setup And Use A Laser Cutter With Rd Works Here

Once the software is installed, a menu typically appears to install the USB driver. This step is crucial for your computer to recognize the laser cutter.

Setting up and using a laser cutter with RDWorks involves a few key stages: installation, physical connection, and preparing your design for cutting or engraving. 1. Installation & Setup

For a more stable connection over long distances, you can configure a static IP address on both your PC and the machine. How to setup and use a laser cutter with RD Works

Run the installation file and select "Install".

Use the cable provided and plug it into the port labeled "PC" on the machine (avoid using the port for USB flash drives). Once the software is installed, a menu typically

You can connect your computer to the laser cutter via USB or Ethernet.

Before connecting your hardware, you must install the software and its drivers correctly. Use the cable provided and plug it into

In the setup window, select your language and preferred unit of measurement (mm or inches). 2. Connecting the Machine