Unit Usp 1020d Instruktsiia Here

Press the MEM button. It will first show the average of the last 3 readings. Press it again to scroll through previous entries.

The will flash. Use the MEM button to change the value, then press SET to confirm. Repeat this process for Month , Day , Hour , and Minute . Preparing for Measurement unit usp 1020d instruktsiia

Sit upright in a chair with your back supported and feet flat on the floor. Cuff Placement: Place the cuff on your bare left arm. Position it about 1–2 cm (0.5 inches) above the elbow. The air tube should run down the center of your inner arm. 🩺 Taking a Measurement Press the START/STOP button. Press the MEM button

Once the measurement is complete, the cuff deflates, and the screen displays: Systolic (top number) DIA: Diastolic (bottom number) PULSE: Heart rate per minute The will flash

Remove batteries if the device will not be used for more than 3 months.